Ignition Switch
This feature allows the driver to operate the ignition switch with the push of a button as long as the key fob is in the passenger compartment.
The START/STOP ignition button has several operating modes that are labeled and will illuminate when in position. These modes are OFF, ACC, ON/RUN, and START.

START/STOP Ignition Button
|
1 — OFF |
|
2 — ACC |
|
3 — ON/RUN |
The push button ignition can be placed in the following modes:
OFF
-
The engine is stopped.
-
Some electrical devices (e.g. power locks, alarm, etc.) are still available.
ACC
-
Engine is not started.
-
Some electrical devices are available (e.g. power windows, etc.).
ON/RUN
-
Driving position.
-
All electrical devices are available (e.g. climate controls, etc.).
START
-
The engine will start (when brake pedal is pressed).
Note:
If the ignition switch does not change the mode by pushing the button, the key fob may have a low or depleted battery. In this situation, a backup method can be used to operate the ignition switch. Put the nose side (side opposite of the emergency key) of the key fob against the START/STOP ignition button and push to operate the ignition switch.

Depleted Key Fob Battery Procedure
WARNING:
-
When exiting the vehicle, always remove the key fob from the vehicle and lock your vehicle.
-
Never leave children alone in a vehicle, or with access to an unlocked vehicle.
-
Allowing children to be in a vehicle unattended is dangerous for a number of reasons. A child or others could be seriously or fatally injured. Children should be warned not to touch the parking brake, brake pedal or the gear selector.
-
Do not leave the key fob in or near the vehicle, or in a location accessible to children, and do not leave the ignition of a vehicle equipped with Keyless Enter ‘n Go™ in the ON/RUN position. A child could operate power windows, other controls, or move the vehicle.
-
Do not leave children or animals inside parked vehicles in hot weather. Interior heat buildup may cause serious injury or death.
CAUTION:
An unlocked vehicle is an invitation for thieves. Always remove key fobs from the vehicle and lock all doors when leaving the vehicle unattended.
Note:
-
When opening the driver's door with the ignition in ON/RUN (engine not running), a chime will sound to remind you to place the ignition in the OFF position. In addition to the chime, the message will display “Ignition Or Accessory On” in the cluster.
-
For more information on normal engine starting procedures, see "⇨STARTING THE ENGINE".
Download Manual